PLEASE READ INSTRUCTIONS CAREFULLY BEFORE ATTEMTPING TO PROGRAM YOUR NEW REMOTE!
Programming procedure for an ANSA remote:
1. Locate the start button on the receiver (this is the white oval button just below the light on your door control box), press this button for 5 seconds and release when the red LED goes out (the LED is just to the left of the oval button). The LED will flash once to confirm you are in add mode.
2. Take the new transmitter and press the button that you wish to use once. The red LED indicator should flash once.
3. Either wait 30 seconds or press the start push button once to reset to normal operation.
4 channel transmitter 433Mhz.
If you order this remote, you will receive the Ansa Deco TX4 as the replacement!
Comes complete with instructions.
Please do not confuse this remote with the similar GR4000 Universal cloning remote. The remotes are not compatible. The Ansa Metallo is a genuine Ansa replacement remote which has unique Ansa coding.
Please Note if your Ansa remote says Henderson on the front or back then please give us a call for a compatible replacement remote.
Batteries: 12 VOLT 27A (Included)
Dimensions: Length: 5.5 Width: 2.8
|Number of Buttons||No|
|Info||Our Ansa Metallo gate and garage door remote control comes complete with batteries and full step by step programming instructions. Our customer service and technical team are here to help you every step of the way if you need any help setting up your remote. Please give us a call if you need advice on which remote control transmitter to purchase.|
|Additional Information||Ansa Metallo Gate & Garage Door Remote Fob Transmitter|
|Left or Right Handed Motor||No|
|Sliding or Swinging Gates||No|
|Number of Buttons||Four|