PLEASE READ INSTRUCTIONS CAREFULLY BEFORE ATTEMTPING TO PROGRAM YOUR NEW REMOTE!
Programming your new Aprimatic TR4 or TM4 remote, Stand as close to the gate or door receiver, take an existing working remote and your new remote then:
- Press ALL of the buttons at the same time (2 buttons on 2 channel remotes and 4 buttons on 4 channel remotes) of a remote which is already in use until you hear the receiver make a continuous beeping noise (the beep continues for a maximum of 30 seconds, within which the new remote must be saved). then release.
- Press All of the buttons on the new remote at the same time. The sound will stop for a moment (approximately 1.5 seconds) and then start again.
- Press a button on the new remote which you would like to use to operate your system. The sound will stop for a moment (approximately 1.5 seconds) and then start again.
- Wait for the beeping to stop then try your new remote.
Note: if all the buttons are not pressed down at the same time, the receiver does not recognize the new remote control.
“If you need help you can give us a call on 01302 700650 or scan the QR code at the bottom of the page or even watch our short video by visiting the link below”
Please note that by ordering this Aprimatic TR4 remote you will recive the direct genuine compatible manufacture replacement Aprimatic TM4
4 channel transmitter 433Mhz.
Comes complete with instructions
Batteries: 1 x 12Volt LR23A (included)
Dimensions - L:5.5cm W:4cm
|Number of Buttons||No|
|Info||Our Aprimatic TR4 gate and garage door remote control comes complete with batteries and full step by step programming instructions. Our customer service and technical team are here to help you every step of the way if you need any help setting up your remote. Please give us a call if you need advice on which remote control transmitter to purchase.|
|Additional Information||APRIMATIC TR4 Gate & Garage Door Remote Fob Transmitter|
|Left or Right Handed Motor||No|
|Sliding or Swinging Gates||No|
|Number of Buttons||Four|